Section 3: PFS5060 Assembly & Set-Up
PFS4000, PFS5060 & PFS8010 Pendulum Spreaders 309-124M
11/20/20
18
The following instructions are for the PFS5060 model.
See page 16 for PFS4000 and page 21 for PFS8010
models. See page 14 for drive unit assembly instructions.
Drive Unit Assembly to Main Frame
Refer to “Section 1: Drive Unit Assembly” on page 14 for
instructions on how to assemble the drive unit.
Refer to Figure 3-1:
IMPORTANT:
Drive Unit assembly is heavy and
requires 2 people to safely install to the main frame.
Do not tighten nuts (#4 & #6) until after hopper is
installed. This will allow for proper alignment of
hopper to drive unit assembly.
1. Insert M12 x 50 (2") bolts (#5) into front holes and
M12 x 40 (1 1/2") bolts (#3) into the back holes of
drive frame (#1).
2. Attach drive frame (#1) to inside slots “B” first and
outside slots “A” last in mounting plate (#2) with hex
nuts (#4 & #6). Do not tighten hex nuts at this time.
NOTE:
If rear bolts (#3) are difficult to install into
slots “A” in mounting plate (#2), pivot rear of drive
unit up and down to insert bolts through slots “A”.
Section 3: PFS5060 Assembly & Set-Up
Drive Unit Assembly
Figure 3-1
30764
2" Lg. Bolts
1 1/2" Lg. Bolts
