Section 1: Drive Unit Assembly
PFS4000, PFS5060 & PFS8010 Pendulum Spreaders 309-124M
11/20/20
15
Shaft Shield Assembly
Refer to Figure 1-3:
1. Position shaft shield (#1) with hole in shield up.
2. Center shaft shield over drive shaft and attach shield
to drive unit with three #10 x 3/4" self taping
screws (#3) and fender washers (#4). Tighten self
taping screws.
3. Position regulation bar (#5) with numbers on bar in
front of adjusting nut and facing to the left
4. Rotate front of regulation bar (#5) away from drive
unit and hook end of bar to gate fork “A”.
5. Push on regulation bar until end of adjusting nut is
against drive unit housing.
MIN, MID, & MAX Decal Placement
Refer to Figure 1-4:
If the three (Max., Mid., & Min) decals are include, peel
their backing paper and place them on the drive unit as
noted below.
1. Place “Max.” decal above the angle adjustment cover
on the smooth flat area provided.
2. Place “Min.” decal below the angle adjustment cover
on the smooth flat area provided.
3. Place “Mid.” decal in-between the “Max.” and “Min.”
decals as shown.
Min & Max Decal Location
Figure 1-4
4. The drive unit is now ready to be assembled to the
main frame. Continue as follows:
•
Go to page 16 for PFS4000 Assembly & Set-Up.
•
Go to page 18 for PFS5060 Assembly & Set-Up.
•
Go to page 21 for PFS8010 Assembly & Set-Up.
30922
Angle Adjustment Cover
Shaft Shield Assembly
Figure 1-3
30780
Locate numbers this side of
regulation bar & adjusting nut.
Adjusting nut.
Hole in shield
Drive shaft
