![background image](http://html1.mh-extra.com/html/land-pride/pfs4000/pfs4000_operators-manual_3508961034.webp)
Section 6: Options & Accessories
PFS4000, PFS5060 & PFS8010 Pendulum Spreaders 309-124M
11/20/20
30
Small Seed Kit
309-136A
SMALL SEED LIMITER KIT
Refer to Figure 6-7:
The Small Seed Kit closes the front two gate
openings “B” to allow fine metering of small seed through
the back center gate opening. Examples of small seed:
Clovers, Granular Pesticides, Alfalfa, Bermuda Seed,
etc.
1. Loosen both nuts (#1) and remove agitator (#2) from
agitator shaft (#6). Save for reuse.
2. Remove agitator cap (#3).
3. Install seed limiter plate (#4) over agitator shaft (#6).
Make sure limiter plate ears “A” are inserted into holes
“B”.
4. Replace agitator cap (#3) and secure cap with hose
clamp (#5).
Small Seed Limiter Kit And Assembly
Figure 6-7
30783
Hopper Top Extension Kit
309-127A
PFS5060 TOP EXTENSION 240 LB
309-128A
PFS8010 TOP EXTENSION 480 LB
309-129A
PFS8010 TOP EXTENSION 960 LB
Refer to Figure 6-8:
1. Remove bolts, washers and nuts (#1, #2 & #3).
2. Center hopper extension (#4) on hopper with tall side
facing forward.
3. Drill 10 mm (13/32") diameter holes up from the
bottom through the hopper extension.
4. Attach hopper extension with existing M10 bolts (#1),
flat washer (#2) and hex nuts (#3).
5. PS8010 only: Position flat face of bolts facing forward
and tap bolt heads in before tightening.
6. Hand tighten nuts (#3) with a hand wrench. Do not
use a power wrench.
Hopper Top Extension Kit And Assembly
(PFS5060 Extension Shown)
Figure 6-8
NOTE:
It may be necessary to clamp hopper
extension against hopper and hopper support ring to
start washers and nuts.
NOTE:
Install hopper extension with tall side facing
forward. All four sides are equal length on hopper
extension part number 309-129A.
NOTE:
Use foam tape with adhesive backing or
silicone caulk between hopper and hopper
extension if concerned product will seep at joint line.
30776