Section 6: Options & Accessories
PFS4000, PFS5060 & PFS8010 Pendulum Spreaders 309-124M
11/20/20
29
11.
Refer to Figure 6-4:
nut (#19) on “0” as shown.
12. With tractor hydraulic control lever, fully extend
hydraulic cylinder (#4).
13. Push regulation bar adjusting nut against drive unit
housing.
14.
Refer to Figure 6-5:
hopper bottom. The openings should be fully closed
and not open as shown in the illustration.
15.
Refer to Figure 6-4:
If gate openings are not fully
closed, adjust regulation bar adjusting nut (#19) until
gates are fully closed.
16.
Refer to Figure 6-2 on page 28:
bracket (#13) to mounting bracket (#14) by tightening
hex socket flat head screw (#1A) first and then (#1B).
17. If screw (#1B) will not tighten, remove self locking
nut (#12) and hex nut (#3). Remove cylinder (#4),
adjusting bracket (#13) with mounting bracket (#14)
from stud (#2). Tighten hex socket flat head screw
(#1B) to the correct torque.
18. Reattach mounting bracket to stud (#2) with nut (#3).
and cylinder (#4) to arm (#9) with locking nut (#12).
Tighten nuts to the correct torque.
PFS5060 & PFS8010 Agitator
Extension Kit
309-134A
PFS5060/8010 AGITATOR EXTENSION
Refer to Figure 6-3:
PFS5060 & PSF8010 Agitator Kit And Assembly
Figure 6-3
IMPORTANT:
Do not use Agitator Extension Kit
when spreading granular or prilled fertilizer. The
agitator extension is only intended for material that
does not easily flow through gate openings such as
damp fertilizer, lime, etc.
NOTE:
Assembly of spring retainer (#2) is easier if
agitator (#3) is removed from hopper and drive unit.
30782
Gate Adjusting Nut
Figure 6-4
Gate Openings Not Fully Closed
Figure 6-5
CAUTION
!
To avoid minor or moderate injury:
Keep body and body extremities clear of recoiling forces while
attaching spring retainer (#2) to agitator (#3).
1. For easier installation, loosen nuts (#4) and remove
agitator (#3) from drive unit.
2. One of the three ears (A1, B1 & C1) is slightly thicker
and one of the three slots (A2, B2 & C2) is slightly
wider. For instructional purposes, mate the thicker
ear (A1) with the wider slot (A2). See Note above.
3. Install slots (A2, B2 & C2) over ears (A1, B1 & C1)
respectively as shown.
4. Secure extension agitator (#1) to agitator (#3) with
spring retainer (#2) as follows:
a. Pivot extension Agitator (#1) at ear A1 by raising
the far side from ear A1 up.
b. Catch center of retainer (#2) under ear (A1).
c. Snap spring retainer end (B3) under ear (B1).
d. With a large pair of pliers, snap spring retainer end
(C3) under ear (C1).
5. Install agitator (#3) to drive unit output shaft (#5) and
tighten hex nuts (#4) to the correct torque.
30789
19
4
Push Adjusting Nut (#19)
Against Drive Unit Housing
Set Adjusting
Nut (#19) on “0”
30790
20
NOTE:
Some grinding on the sides of ear (A1) may
be required to fit slot (A2) over ear (A1) properly.
