Lamtec BT300 BurnerTronic, Manual

Page: 220 / 254

219
8 Options
8.5.2.2 DIP Switch
All settings of the device are configured by means of DIP switches.
Tab. 8-2 Function of the DIP switches
8.5.2.3 LEDs
EBM100 has 4 LED and 2 additional LED at the RJ45 socket, which should be connected as
described below:
Tab. 8-3 LED signalling
DIP switch no. Settings
1 - 2 1 2
0 0
0 1
1 0
1 1
LSB Family
1
2
3
4
3 CAN terminal resistance
LED Colour Description
PWR green ON: Module working in normal mode = fully initialised and
without any fault.
CAN green OFF: No communication or CAN BUS error
Flashing with 2 Hz: Sporadic errors (optional, if a CAN
warning is detectable).
ON: CAN is functioning.
ETH green OFF: No communication on Ethernet
Flushing with 2 Hz: Ethernet – Fieldbus is initialised. Mas-
ter/Client not connected
ON: Master/Client is connected. Communication by Ether-
net is failure free.
ERR red OFF: No error.
Flashing with 2 Hz:
– No CAN message for more than 3 s.
– IP configuration does not correspond with the specifica-
tions in the BT parameter.
ON: EBM100 not ready.
ACT yellow OFF: No Ethernet activity
Flashing: Module is sending/receiving Ethernet frames
LINK green OFF: Ethernet connection is active
Flashing: – no connection to Ethernet
ERR ETH CAN PWR Condition
OFF ON ON ON Device started, no error:
– CAN bus OK,
– CAN communication OK,
– Fieldbus master connected
OFF Flashing X
1
ON – Device started
– Fieldbus master not connected