Lamtec BT300 BurnerTronic, Manual

Page: 153 / 254

152
6 Operating Control and Displays
Proceed cold check (check digital outputs)
1. Click in menu on ’Cold check’.
The dialogue to proceed the check of outputs starts.
2. Start cold check via button ’Start cold check’.
3. To start settings confirm the message with OK.
NOTICE
Not confirming this message during default time with OK, aborts the process.
The process can be repeated immediately.
4. To activate cold check mode confirm message with OK.
NOTICE
Not confirming this message during default time with OK, aborts the process.
The process can be repeated immediately.
Cold check mode is activated now. To illustrate this status, the choice box of outputs re-
ceives a red frame.
5. Select the output to be activated.
6. To activate the output confirm message with OK.
NOTICE
Not confirming this message during default time with OK, aborts the process.
The process can be repeated immediately.
The chosen output will be activated.
NOTICE
Activating just one output at a time is valid. As soon as another output in the output selection
field is selected, the active output selected earlier will be reset.
7. Click button ’Close cold check’ to finish cold check. The window remains open.
8. Click button ’Close’ to close window. This terminates cold check.
Device-Information
1. Click in the menu on ’Device-Information’.
The window device-information opens. Information about the remote device is indicated.
Fig. 6-76 Start cold check