Lamtec BT300 BurnerTronic, Manual

Page: 188 / 254

187
8 Options
Definition of terminal assignment
0 = oil operation - two-stage or modulating
1 = oil operation - three-stage (pilot burner not available)
2 = gas operation - modulating
X26 is process status signal (from version 3.7.0.0)
3 = dual fuel - oil operation - modulating or two-stage or gas operation - modulating
pilot burner permitted (BT340 only)
4 = dual fuel - oil operation up to three stages (without pilot burner) and modulating
gas operation (BT340 only) Group: 85
Min.: 0
Max.: 65535
Default: 2
Write: 2
Version: 1.0.0.0
5 = oil operation - two-stage or modulating
X26 is process status signal, not oil pump
6 = oil operation - three-stage (pilot burner not available)
X26 is process status signal, not oil pump
7 = two-stage oil operation - modulating or 2-stage or Gas operation - modulating,
pilot burner permitted (BT340 only)
X26 is process status signal, not oil pump
8 = two-stage oil operation up to three stages (without pilot burner) and
gas operation modulating (BT340 only)
X26 is process status signal, not oil pump
9 = output and input for BT335 two-stage operation (only possible with BT335)
from Version
3.7.0.0 on
10 = Gas/gas programme, IOs, same as 2 (gas).
Switchable via DFM into 2 gas trains.
from Version
3.9.0.0 on
0812 BT300 Definition of source for curve set selection
Definition of source for curve set selection
0 = curve set selection with P 808
1 = curve set selection via terminal at Dual Fuel Module (DFM)
2 = curve set selection via LSB (p.ex. PBM)
Group: 85
Min.: 0
Max.: 3
Default: 0
Write: 2
Version: 1.0.0.0
3 = using X21 for curve set selection (only possible for BT335; P 801 = 9) Version: 3.7.0.0
Max.: 3
No. Device Description Attribute
0525 BT300 Setting of number of stages for staged operation in oil mode
Setting of number of stages for staged operation in oil mode
0 = 1 stage = modulated operation
1 = 2 stages
2 = 3 stages
Group: 60
Min.: 0
Max.: 2
Default: 0
Write: 2
Version: 1.0.0.0
0801 BT300 Definition of terminal assignment