27
Optional straight line rip stop
Adjusting screws Lock handles
Fit the
optional
straight-line rip stop at the end of the table as shown.
The
optional
side extension table, comes with the clamp bar attached. Loosen the ratchet
handles and slide the bar into the slot on the side of the side of the sliding table. Attach
the table and level as follows
.
Straight edge Vertical adjusting screw
To adjust the optional side extension table, lay a straight edge level on the sliding table,
and extended over the side extension table. Loosen the two clamping handles; adjust the
vertical adjustment screws so that the edge of the side extension table is level with the
sliding table. Re-clamp and re-check with the straight edge.
To get the side extension table parallel with the sliding table adjust the two plastic screws
located under the table. Only adjust the screws with the ratchet clamp handles loose.
Side table adjustment
Summary of Contents for TS SERIES
