laguna TS SERIES, Manual

Page: 37 / 78

37
Do not attempt this procedure unless excessive movement has taken place during
shipping.
Top nut
Sliding table adjustment Bottom nut
1 / Lock the sliding table in position with the table lock knob.
2 / Using a straight edge across the sliding table check the gap between the straight edge
and the main table at both ends of the man table.
3 / If adjustment is needed loosen the lower nuts ¼ turn only. Do not loosen the top nuts
4 / Adjust the top nuts so that the gap under the straight edge is parallel and at about
0,02”.
5 / Check that all the top nuts are in contact with the support steel and that there is no
rocking.
6 / Tighten the lower nut and re check. If fine-tuning is required repeat procedure.
Sliding table adjustment for parallel with the saw blade.
Wood at front of saw blade
Wood at back of saw blade
The table must run parallel with the saw blade. The gap between the edge of the sliding
table and the table is not important.
To check if the table is running true, clamp a piece of wood [1” x 1” or 2” x 2”] to the
table using the miter fence clamp. Cut the wood slowly. The teeth of the saw blade
should make contact with the front and the back of the blade evenly.