laguna TS SERIES, Manual

Page: 39 / 78

39
Sliding table ground steel rods damaged or warn.
Remove end cover
Clamp screws Steel rods
If the steel rods become damaged or warn, a new face can be presented to the ball
bearings as follows.
1 / Loosen the clamping screws at each end of the sliding table.
2
/ With a brass rod, knock the rod out +_ 1”.
3 / Rotate the rod +_20 degrees.
4 / With the brass rod, knock the rod back level with the end of the table, and retighten the
clamping screws.
5 / Repeat until all the rods have been turned.
Vertical mechanism tight.
Guide plate
Bearing plate
1/
Check that nothing is jamming the mechanism
2 / Check that the worm gear and screw are clean and lubricated.