laguna TS SERIES, Manual

Page: 17 / 78

17
To fit a blade, disconnect the saw from the power. Move the arbor to the maximum up
position. Rotate the saw arbor so that the hole in the arbor lines up with the hole in the
saw table. Insert the locking rod, and loosen the arbor nut. Remove the large clamping
disc, and fit the blade. When refitting the clamping disc, ensure that the key lines up with
the key way. The nut must be tightened, and the locking rod removed before starting the
machine.
Note. The arbor has a left hand thread.
Note. The arbor is shown with the spacer removed. The spacer is only removed when you
fit a dado cutter. It is left on the arbor when fitting a saw blade.
Dust cover clips
Locking rod
Loosen
To release the yellow dust cover, release the clips at both ends. Never move the saw
arbor with the dust cover loose, as it could become damaged .
Guard in up position
Guard in down position
Fit the saw blade guard, and fit a dust hose if required. The size of dust hose should be 1
½”.
Fitting a blade