laguna TS SERIES, Manual

Page: 40 / 78

40
3 / Check that the guide plate is not jamming. Clean and re lubricate. Ensue that you clean
the whole guide plate by moving the saw arbor to fully up and fully down, cleaning the
exposed part of the guide plate.
4 / Inspect the guide plate and bearing plate for ware and damage. If damaged or warn,
replace.
Clamp screws Leveling screws
Lock nut Adjusting screw
5/ If the worm gear is warn or excessively tight adjustment is provided.
Note . Contact your supplier before attempting to adjust the worm gear / screw clearance.
You could cause damage or your warrantee could be affected.
Tilt mechanism tight
Tilt worm gear and screw
1/
Check that nothing is jamming the mechanism
2 / Check that the worm gear and screw are clean and lubricated.
3/ If the worm gear is excessively tight or worn, adjustment is provided.
Note . The adjustment mechanism is similar to that shown above for the vertical
mechanism.
Note . Contact your supplier before attempting to adjust the worm gear / screw clearance.
You could cause damage or your warrantee could be affected.