laguna TS SERIES, Manual

Page: 31 / 78

31
Push the shaft through the casting so that the dowel pin lines up with the slot in the bush.
Make sure that the spring is in position.
Assemble the stop bushing, and the screw in the back of the casting.
Assemble the vertical adjustment assembly on the back of the trunnion assembly.
Fit the locking bolt.
Use a straight edge line up the two flanges as shown and tighten the locking bolt.
Fitting the adjustment screw
Fit the double threaded allen set screw as follows.
Push the assembly back as far as it will go and hold in position.
Thread the double threaded set screw in by hand until it contacts the inner thread.
Using an allen key continue to screw the screw in while slowly allowing the pressure of
the screw to push the casting forward.
Once the thread has engaged you can release the casting and continue to tighten the
screw.
Care must be taken during this assembly as you could damage the thread.
Vertical adjustment screw Vertical adjustment access hole
Vertical adjustment screw
Lining up the scoring unit