laguna TS SERIES, Manual

Page: 21 / 78

21
Straight edge
Extension table Jack screw
Using a straight edge, adjust the legs so that with the straight edge flat on the main table
the part of the extension table that is directly above the legs is level with the table.
Above the table fixing bolts are leveling screws. Adjust the leveling screws so the table is
level with the main table, and fully tighten the fixing bolts.
Note . The table is attached to the side angles, and after you have completed all the
adjustments, you will have to drill through the holes in the angles, and attach the table to
the angles, with the screws and nuts provided. Do not drill the holes at this point in time.
Note . Do not level the table or attach the angles until the machine is in the final position.
Fence tube Side angle
Tube fixing bolts
View from underside of tube and
angle
Fit the angle iron rails to the side of the main table. Make sure that the angle with the
fence holes is on the side of the machine with the on / off switch. Use the countersunk
screws to attach the angle to the main table.
The angle on the other side of the machine is attached with hex bolts.
Fit the fence tube to the angle with the hex bolts and washers from the under side of the
angle. It is recommended that this be assembled with two people, as the tube has a
tendency to slide off the angle during assembly.
The angles will have to be adjusted vertically and this is covered latter.