laguna TS SERIES, Manual

Page: 34 / 78

34
Fit the scoring blade.
Note . Scoring blades are supplied with shims that are used to adjust the width of the
scoring blade, to suite the saw blade that you are using.
Note . The scoring blade rotates in the opposite direction to the main blade.
Adjust the blade so that it is 1/16’ above the saw table. Access to the vertical adjustment
is through the hole in the table [Shown in previous view]
.
If the scoring blade is cutting too far left or right, loosen the clamp screw and move the
adjustment screw in or out.
Note . The adjustment is very fine.
Dado cutter
Scoring blades Scoring shims and spacers
Fitting Dado scoring [Optional].
If you dado laminates or plywood, it is an advantage to score the surface to prevent
chipping. The scoring unit can be used to do this as follows.
1 / Measure the width of the dado cutter or cut a slot with the dado and measure the slot.
2 / Fit the inside blade of the scoring set onto the shaft, and select shims and spacers to
suit the slot widths [less the width of the two scoring saw blades].
3/ Place the shims, and the outside blade on to the scoring unit shaft, and lock in position
with the nut and washer.
4 / Adjust the height of the scoring cutter so that it is 1/16” above the table.
5 / Make a trial cut on a piece of scrap.
6 / Check that the inside cutter of the scoring unit is cutting inline with the inside cutter of
the dado cutter, and adjust if required.
7 / Check that the outside cutter of the scoring unit is cutting in line with the outside cutter
of the dado and adjust the shims / spacers if required.
Note . The scoring blade rotates in the opposite direction to the main saw blade.
Hold
shaft with
allen
wrench