laguna TS SERIES, Manual

Page: 24 / 78

24
To fit the measurement tape.
Marking the fence tube
Assembling the measurement tape
1 / Clean the steel tube with solvent to remove all traces of grease and dirt.
2 / With a blade fitted, and the power disconnected from the machine, fit the fence to the
tube and push it up against the blade so that it is just touching.
3 / Mark a point on the tube with a pencil or pen at the curser line.
4 / Remove the fence. Line the end of the tape up with the pencil mark and peel off the
backing in short sections, sticking the measurement tape to the tube.
Fine adjusting slots
Fine adjustment of the hair line can be done in a number of ways but the most effective
way is to lock the fence [1”] and to cut a piece of wood. Measure the wood and adjust the
hairline read out.
Note . Do not over tighten the read out as you may crack the plastic.It is possible to adjust
the read out closer to the tape by inserting washers between the two parts of the readout.
Make sure that the plastic is not in contact with the tape at any point along its travel.