70
PLM Series Operation Manual rev 1.1.3
10. Back Panel Interface
10. Back Panel Interface
10.1 Power Inlet
A Neutrik NAC3 Series PowerCon connector rated at 32 A is fitted to the rear of the PLM for AC mains
input. The power cable (AC cord) supplied with the PLM has the mating connector ready-fitted, but may
require a mains (AC) plug specific to your country to be fitted to the other end. See section 5.5 for wiring
details.
10.1.1 PowerCon
®
wiring details
If it is necessary to rewire the PowerCon connector, or to make custom power cables for your particular
installation, please observe the following connection details:
PowerCon Pin
230 V Version
115 V Version
L
Brown
Black
N
Blue
White
Green/Yellow
Green
Table 10.1.1: PowerCon connector wiring and pin out
10.2 Audio Input and Links
10.2.1 Analog inputs and links
INPUT
1
INPUT 2
LINK
1
LINK 2
PIN 1: SCRN 2: POS 3: NEG
ANALOG WITH
I
SO-
F
LOAT
TM
Figure 10.2.1a: Rear panel analog input/link field
The electronically-balanced analog inputs are on XLR3F connectors. The Link outputs on XLR3M connectors
are directly paralleled to the inputs. All XLRs are wired to IEC268 as follows in figure 10.2:
Pin 1: Ground/shield
Pin 2: Hot (+)
Pin 3: Cold (-)
Figure 10.2.1b: Analog XLR wiring and pin out
