Kyoeisha Baroness LM531, Service Manual

Page: 50 / 161

Important
If a used taper pipe (PT) thread joint retains
the residue of old sealing tape, using it again
for assembly may cause machine problems or
oil leakage.
Important
If you remove a taper thread joint, remove the
sealing tape residue from the joint and
connecting portion, so that the tape residue
will not enter the hydraulic system.
1
14d3iz-002
Taper Pipe (PT) Thread Joint (Sealing Tape Method)_002
1 Taper (PT) thread connecting portion
Before connecting the joint, wind sealing
tape on the taper thread portion.
"How to Use The Sealing Tape" (Page
4-10)
1
14d3iz-003
Taper Pipe (PT) Thread Joint (Sealing Tape Method)_003
1 Taper (PT) thread portion
2.
How to Use The Sealing Tape
Important
Using the sealing tape with its end out of the
edge face may cause a trouble of the machine
due to its debris invading the hydraulic circuit.
1
2
ugh2b1-001
How to Use The Sealing Tape_001
1 Edge face
2 Sealing area
Important
Loosening again the taper thread joint which
has been tightened may reduce its sealing
effect to cause leakage of oil.
Note:
Pay attention to the following precautions
when you use the sealing tape.
Slightly pull the sealing tape (as tight as
you can clearly see the thread mark on the
tape) while you wrap it and overlap a half
of its width to the previous round.
Wrap it in clockwise direction (direction to
tighten the screw).
Wrapping in the opposite direction may
cause the tape to be easily peeled off.
1
2
3
ugh2b1-002
How to Use The Sealing Tape_002
￭
･
･
LM531
Hydraulic System
Page 4-10
General Inspection and Repair