Kyocera ECOSYS FS-2020D, Operation Manual

Page: 118 / 219

7-18 Using the Operation Panel
Copies (Number of copies)
Sets the number of copies printed of the specified file in USB flash
memory.
1
While
Copies
in step 5 above is displayed, press
U
and
V
or
Y
and Z to display the number of copies. (E.g.:
10
)
2
Press [OK] .
Paper Source
and a question mark (
?
) appears.
Paper Source (Selecting the paper feed source)
Sets the paper used for printing the specified file in USB flash memory.
1
While
Paper Source
in step 2 above is displayed, press U and V
or Y and Z repeatedly until the paper source appears.
(For example :
Cassette 2
)
Note that menus shown in the list may vary depending on which
optional units installed in the printer.
2
Press [OK] . The message
Processing
appears and the printer
prints a file stored in a USB memory.
Remove Device (Removing the USB flash memory)
Specifies the setting for USB flash memory removal.
1
Press
Z
while
USB Memory >
is displayed.
2
Press U or V repeatedly until
>Remove Device
appears.
3
Press [OK] . A question mark (
?
) appears.
4
Press [OK] again. Menu display ends and the USB flash memory
device can be removed.
Print File List (Printing a list of the files on a USB
flash memory)
This allows you to print a list of the files on a USB flash memory device.
1
Press Z while
USB Memory >
is displayed.
2
Press U or V repeatedly until
>Print File List
appears.
3
Press [OK] . A question mark (
?
) appears.
4
Press [OK] again. The message
Processing
appears and the
printer prints a list of files stored in a USB flash memory.
IMPORTANT To use this feature, an optional hard disk must be
installed in the printer or the RAM disk must be set to
On
.
Copies
010
Paper Source
? Cassette 1
Paper Source
? Cassette 2
>Remove Device ?
>Print
File List ?