Kyocera Mita 1900N - B/W Laser Printer, Operation Manual

Page: 99 / 286

Operating the Storage Device
1-85
7
In this state, send the file from the computer to the printer.
The file is written onto the storage device given a destination name
(also referred to as a partition name) which the printer automatically
assigns one after another as follows:
DataS001 (first data),
DataS002 (second data),
DataS003 (third data)...
In the example above, if the file TEST.TXT is the first data to be
written onto the storage device, the destination name will be
DataS001 .
As the printer receives data, the message display changes to
Processing
, then when the end of the data is received, the message
display changes to
Waiting
.
8
Check that the message display has changed to
Waiting
, then press
the GO key. This writes the file to the memory card and instructs the
printer to automatically print out a CompactFlash card write
information page as shown below.
Partition Type . Type of data written (currently only type 2 is supported).
Partition Name . Name of data written.
Write Partition Length . Length (size) of the data written.
Others . Additional information, such as error information.
When the write information page is printed, the message display
returns to
Ready
.
If the writing was not completed successfully, an error code appears
on the message display. For details, see Error Messages on page
4-10
. If this happens, press the
GO
key. The message display returns
to
Ready
.
FS-1900 Page Printer
WRITE INFORMATION