Kverneland Electrical Control EC, Operation Manual

Page: 32 / 69

Flowmate Control FMC
OPERATING INSTRUCTIONS
32
§4.3 F
ILLING AND RINSING FUNCTION
From Main screen 1 you reach the “Filling and rinsing function” screen by pressing the arrow
key 2x, when the central switch Spraying is "OFF" (see fig. page 26).
Filling function: Rinsing function:
To switch over to the other function, press the
OK key , the Spray tank or Water tap symbol
flashes. With the arrow keys or switch to the other symbol and confirm with the OK
key .
The display shows the amount of fluid necessary to fill or to rinse the conduit system. The
amount of fluid depends on the length and the cross-section of the individual line sections
which have to be filled or rinsed and on the number of sections switched on. The necessary
data of the conduit system have already been programmed ex works and can be amended
if necessary in the
Service menu .
§4.3.1 Filling function
With the help of the filling function, the conduit system can be filled with spraying fluid up to
the nozzles at the start of spraying work. This means that spraying fluid is available directly
at the nozzles at the start of spraying at the edge of the field and you can start immediately
when you have switched on.
Mode of procedure in filling the conduits:
-
Central switch for Spraying to “Off” .
-
Set all the valves on the sprayer to the “Spraying” position (see operating instructions
for sprayer).
-
All section switches to “On” . The display shows the amount of fluid needed in litres.
-
Central switch for Spraying to “On” . This initiates the filling process.
The through flow amount is used to calculate the residual amount of filling water and
displayed. Each filled section is automatically switched off by the computer.