Kverneland Electrical Control EC, Operation Manual

Page: 30 / 69

Flowmate Control FMC
OPERATING INSTRUCTIONS
30
§4.2.2 Setting of nozzle and drop size
If the nozzle type/size used and the required drop size are entered here, the computer can
warn the user if the admissible working range of the nozzle is exceeded.
-
To enter the nozzle type, press the OK key 2 times , so the nozzle designation flashes.
-
By pressing either or select nozzle type/size and confirm with OK key , the next
parameter (drop size) flashes.
-
By pressing either or select drop size and confirm with OK key , the next
parameter (consumed amount) flashes.
A maximum of 4 different nozzles, which can be pre-programmed in the Setting menu
(SETUP FUNCTIONS) are available for selection.
There are the following possibilities of selection for the drop sizes:
Very fine
Fine
Medium
Large
Very
large
If the selected nozzle type does not support a drop spectrum, for example as with injector
nozzles, a cross appears on the display. In this case, there is no possibility of setting for the
drop size.
N.B.: The warning reports with regard to the pressure range and drop size have no
influence on the automatic regulation of the application rate.
The computer can also make suggestions for the selection of the matching nozzle size (see
paragraph §4.6
“Nozzle recommendation” ).
§4.2.3 Amount consumed
Here, the amount of fluid sprayed is displayed in litres.
The value can be deleted as follows:
-
Press the OK key 2 times , then press the arrow key until the value flashes.
-
By pressing the arrow key delete the value and confirm with the OK key , the next
parameter (sprayed area) flashes.
The value displayed here can also be transferred to the parcel memory (see paragraph
§4.4
“Parcel memory” ).
XR110
04
Admissible max. pressure reached
Admissible min. pressure reached
Drops too large/small