Kurzweil KDFX, Manual

Page: 38 / 164

Inside KDFX
Exploring the Studio Parameters
3-6
Exploring the Studio Parameters
WeÕll explore the parameters within the Studio in the order in which they affect the signal path,
starting on the Input page.
Input section
.
Figure 3-2. Input editor
Inputs are referred to as A, B, C, and D, and correspond to the four output buses (KDFX-A
through KDFX-D) from the K2500Õs VAST Program editor. These signals can be treated as stereo
pairs or as individual mono signals. This is determined by the Þrst parameter on each Input
page, the Mono/Stereo switch.
If this switch is set to ÒMÓ, then the left and right channels of the selected Program output pair
are split up, and each is given its own Input page, with EQ and FXBus routings. If it is set to
ÒSPÓ (Stereo with Pan) or ÒSBÓ (Stereo with Balance), the two channels of the pair are processed
in parallel.
Selecting the Mono/Stereo mode on one Input bus does not affect any of the others, and you
can have any combination of stereo and mono Inputs in a Studio. Therefore, there can be
anywhere from four to eight Input pages in a Studio.
The Chan/Bank Up and Down buttons let you move among the Input pages.
K2500 output pair
stereo or L R (if mono)
Level,
Pan/Balance
Width (if stereo)
two-band EQ
Mono/Stereo
switch
To FXBuses 1-4
EditStudio:INPUT||||||||||||<>Input:||A|
||A||LoShelf||HiShelf||FXBus1||FXBus2
|||G:0.0dB||G:0.0dB||Lvl:0.0dB|Lvl:Off
|||F:123Hz||F:9956Hz|Pan:0%||||Pan:0%
|||||||||||||||||||||Wid:100%||Wid:100%
<more| | INPUT| | FXBUS| | AUXFX| | OUTPUT | more>
SP