KDFX Controller Assignments in Programs & Setups
Programs
Appendix B-1
Appendix B
KDFX Controller Assignments in Programs & Setups
This appendix provides complete KDFX controller assignment information for all of the ROM-based K2500 pro-
grams and setups, including those in the Stereo Piano ROM, Orchestral ROM, and Contemporary ROM.
A Note about Secondary Effects in Programs
Some of the Programs in ROM use a technique called Òsecondary effectsÓ, in which the processing on one or more
layers of the Program can be changed completely with a single button push. Secondary effects in these Programs
are enabled by Panel Switch 2 (MIDI Controller 29), which acts as a toggle, going back and forth between the Òpri-
maryÓ effect and the secondary one. In practice, what this switch does is to turn off (set
Lvl
to
Off
) one of the two
FX Bus sends on an Input page, and simultaneously turns on (set
Lvl
to
0.0dB
) the other FX Bus send.
PSw2 Off: FXBus1||||||FXBus2||||||
||||||||||Lvl:0.0dB|||Lvl:Off
PSw2 On:| FXBus1||||||FXBus2||||||
||||||||||Lvl:Off|||||Lvl:0.0dB
Most of the time, this effects-switching only affects a single Program layer on a single Input pair, although in some
Programs the switching is more complicated, and toggling the Panel switch moves two or more layers to different
FX Buses. PSw2 may also change EQ settings, or it may merely change an Aux reverb's decay time, depending on
the Program.
Here's an example: Program
813 Prs Koto
. It has one layer, routed to Input A. Normally, Input A is routed to FX
Bus 1, which in this case is a room reverb. Pressing PSw2 re-routes this to FX Bus 2, a flanger. FX Bus 2 is also routed
to the ÒBig RoomÓ reverb on the Aux bus (which FX Bus 1 is not), so the reverb changes as well.
In the chart, any controllers that operate exclusively on secondary effects are in
italics
. The line showing the panel
switchÕs operation is also
italicized
.
In this example, Slider B controls the first reverbÕs (Òroom1Ó) wet/dry balance when PSw2 is off. Slider C controls
the Aux room reverb send level when the switch is on. Slider D controls flange level and crosscouple amount when
the switch is on. Panel Switch 2 toggles between room1 reverb and flange.
Programs
Controller assignments for KDFX parameters used by K2500 programs are provided on the following pages.
813
B
C
D
PSw2
Prs Koto
9 RmFlgChDly Room
room1 rvb w/d
aux room rvb lvl
flange lvl, flange Xcouple
toggle: room1 rvb/
flange
Summary of Contents for KDFX
