KS Motorcycles K-LIGHT125, Maintenance Manual

Page: 82 / 278

Remove the alternator wire connector.
Remove the alternator stator (the stator inserts need to
be picked out of the box with a needle).
1.7.2 Installation
Clean the crankshaft and the taper of the flywheel.
Install the flywheel fixed key is installed into the
groove of upper key of the crankshaft and confirm it.
Align the groove on the flywheel with the fixed key on
the shaft.
*Note
The inner surface of flywheel is magnetic, so bolt
should not be installed on it.
Use a universal non-adjustable wrench to secure the
flywheel and then lock the retaining nut.
Install the alternator stator on the left cover of the
engine, install the left cover to the engine, install the
starter gear cover and connect the alternator connector.
Flywheel locking torque value: 50-60 N·m
Stator and box cover locking torque value:
10-12N·m
Trigger locking torque value: 6-9N·m
Stator locking
bolt
Apply an appropriate amount
of oil to the motor hole
The left cover parts are complete and there
is
no foreign body in the coil
- 81 -
KS MOTORCYCLES - https://ksmotorcycles.com