KS Motorcycles K-LIGHT125, Maintenance Manual

Page: 53 / 278

Engine Oil/Filter
Oil level
*Note
•When checking the oil level, the motorcycle must be
parked on a flat surface.
•Check the oil level after the engine has run for 2-3
minutes or been parked for about 2-3 minutes.
Check the oil level.
When the oil sensor gives an alarm, replenish the oil to
the upper limit.
Inspection of oil level
*Note
When checking oil level, do not tighten the oil level
gauge.
When checking the oil level, place the center stand at
the flat floor and make the motorcycle body vertical.
When the oil is continuously consumed, check the oil
amount regularly and add it to the appropriate location.
Oil capacity: 1.1±0.1L when changing oil
1.2±0.1L when disassembling
If the oil level is too high, the operation of engine and
clutch may be affected; if it is too low, engine
overheating may be caused and thus components are
worn seriously.
If you add inferior or other brands and grades of oil, the
lubrication effect may be reduced.
After the engine stops, clean the dust on the oil level
indicator at the right cover with a clean cloth.
Put the engine on a level surface, and check the oil
level position at the oil level indicator.
If the oil level is below or near the lower limit, add the
recommended oil to the upper limit mark.
Oil filling port
Oil drain
Upper limit
Lower limit
- 52 -
KS MOTORCYCLES - https://ksmotorcycles.com