KS Motorcycles K-LIGHT125, Maintenance Manual

Page: 111 / 278

5.3.2 Installation of front brake disc
Insert the front brake disc into the edge of rim, and
insert 4 clamp screws [A] after applying one drop of
thread sealant at the end of thread
Tighten the bolt to the brake disc in the form of a cross
step by step, and tighten 6 screws according to the
following torque value:
Torque value:
Clamp screw of brake disc 10-12N·m
*Note
• Do not expose the brake assembly to oil when
installing or removing.
• Use specified cleaning agent to avoid reducing
brake performance.
*Note
If there is grease on the brake shoe, braking
performance will be reduced and the brake will fail.
5.3.3 Inspection of front brake disc
Check the brake disc for wear, and replace it if
necessary.
Measure the brake disc and record the maximum value.
If the thickness of brake disc is smaller than the
maintenance value, it should be replaced.
Specifications
Diameter of front fluid brake disc
φ280mm
Thickness of front brake disc 4.0mm
Allowable limit:
Thickness of front fluid brake disc 3mm
*Note
• Use a micrometer for measurement.
- 110 -
KS MOTORCYCLES - https://ksmotorcycles.com