KS Motorcycles K-LIGHT125, Maintenance Manual

Page: 66 / 278

Inspection of wear of brake pad
●Remove the brake pads (see “Disassemble front/rear
brake pad” in chapter “Brake” for details).
●Check the thickness of friction plate of brake pad
inside the caliper [A].
★
If the thickness of friction plate of any brake pad is
lower than the operating limit [B], replace the two
brake pads inside the caliper simultaneously.
Thickness of friction plate of brake pad
Standard:
Front wheel brake pad: 6.0 mm
Rear wheel brake pad: 6.0 mm
Operating limit: 3 mm
Inspection of CBS
Inspection of CBS
●Check whether the brake fluid in the CBS reservoir is
above the level line.
Check whether there is inner leakage in CBS
●Loosen the adjusting bolt lock screw.
●Make the adjusting bolt screwed and unscrewed using
adjusting bolt.
●Screw adjusting bolt with hands while holding down
the brake pedal. If it can be screwed, there may be inner
leakage, please replace CBS or CBS plunger assembly;
if it cannot be screwed, there is no inner leakage in
CBS. (See “disassemble and assemble CBS pump”
for details)
- 65 -
KS MOTORCYCLES - https://ksmotorcycles.com