Kronoterm HM-130 S1, Instructions For Installation, Use And Maintenance Manual

Page: 7 / 60

7
legislation in force. While performing works on the device, it is necessary to prevent
the coolant to leak into the atmosphere.
WARNING
It is necessary to consider all technical data and instructions in this manual as well as
all warnings and notes during planning, design, installation and use of the device.
WARNING
Electrical installations have to be inspected in accordance with regulations on the
requirements for low voltage electrical installations in buildings by the installer of
electrical installations.
DANGER
Connecting the devices power cable must be performed by a qualified electrician.
During the procedure, the device must not be live.
WARNING
In case the power cable of the device is damaged it has to be immediately replaced.
The replacement can only be performed by the installer or authorised maintenance
worker.
WARNING
Before opening the device, disconnect all electrical circuits and make sure the device
is not live.
CAUTION
Putting any kinds of items on or next to the device is prohibited.
CAUTION
The device must not be placed in a room where it cannot be removed. Later walling or
setting up of other obstacles next to the device is forbidden.
CAUTION
For the correct operation of the device, the electrical distributor has to provide
electricity of adequate quality (SIST EN 50160). In normal conditions, this is within ±
10 % of the rated voltage. The data about the state of the electrical grid have to be
acquired from the electrical distributor.
CAUTION
Connecting the device to the electrical network has to be performed in accordance
with the standards for connecting devices to the electrical network. Connect the
device to the electrical network via the power supply cut-off which is installed into the
electrical installation under the regulations in force.
1.5 Obligations of the end user
The user must ensure uninterrupted and efficient operation of the device by considering the
following instructions:
To thoroughly study the instructions for use and installation accompanying the
device before use.
To have a qualified and authorised installer perform the installation of the device.
To have a contractor for commissions perform the commission.
Allow the authorised contractor for commissioning or ask him or require him to
thoroughly explain the functioning and how to operate the device.
Ensure regular yearly inspections and maintenance of the device by the authorised
maintenance worker.