Kronoterm HM-130 S1, Instructions For Installation, Use And Maintenance Manual

Page: 6 / 60

6
NOTE
High pressure in the heating system can cause water dripping from the safety valve.
Make sure the drainage pipe on the side of atmospheric pressure is open.
CAUTION
A yearly inspection of the safety valve is necessary to ensure its proper operation;
when performing it, remove lime scale and make sure the safety valve is not blocked.
CAUTION
The drainage hole of the safety valve must be directed downwards. Make sure it does
not freeze.
DANGER
Failure to comply with the manual and good practise while connecting the device to
the power supply can lead to serious injury or death.
WARNING
Connecting the device to the power source can only be performed by a qualified
installer.
1.4 Safety warnings and instructions
DANGER
It is prohibited to move, shift, clean or service the device while in operation.
WARNING
It is prohibited to play with the device. Children are not allowed to clean the device
without supervision.
WARNING
The device can be operated independently only by informed persons who are familiar
with the safe operation of the device and understand possible hazards of its operation.
Children older than 8 and people with reduced physical and mental capacities and
with lack of experience and knowledge can only operate the device under the
supervision of an informed person.
WARNING
Before installation and any further adjustments to the device, it is necessary to
consider the instructions for safe use and maintenance.
WARNING
Installation has to be performed in accordance with national regulations on electrical
installations and with the instructions of the manufacturer. It has to be performed by a
professionally trained person.
WARNING
It has to be made sure that the device does not endanger anybody. Access to the
device has to be denied to children and persons who are not informed about the
operation of the device.
WARNING
The device must never be cleaned with cleaning agents containing sand, soda, acid
or chlorides because these might damage the surface of the device.
WARNING
The device contains the refrigerant HFC which is classified as a greenhouse gas
according to the Kyoto protocol. This is why tampering with the cooling cycle is only
allowed to persons authorised for working with the coolant as defined by the national