Kronos 4000 series, User Manual

Page: 104 / 146

Chapter 4 Maintaining the Timeclock
4-56 ADP, Inc.
LED Test
Use LED Test to check the timeclock’s LEDs. During the test, the three LEDs in
the top right corner of the timeclock flash in sequence twice. (The LED test is also
part of the “Sequential Tests” function.) Then, the bottom LED remains lit to
indicate that the timeclock is receiving power.
Sequential Tests
Use Sequential Test to run through the Display, LED, and Beeper diagnostic tests.
The test is finished after sounding two pitches for the Beeper test.
Note
You can run each test included in this Sequential Tests function individually,
using each test’s own maintenance function.
Step Display Action
1 Maintenance Mode idle
display Press the More... soft key.
2 Maintenance Mode
display Press the LED Test soft key.
3 Start Test? Do one of the following:
!
Press ENTER to accept the default answer.
!
Press the toggle soft keys to select YES or NO,
and press ENTER.
Step Display Action
1 Maintenance Mode idle
display Press the More... soft key.
2 Maintenance Mode
display Press the Sequential Tests soft key.