IV - 11
Info Centre
4.4 Feed Drive
The cutting length is determined by the speed of the
feed drive rollers and the number of blades that are
used.
In field mode, the current cutting length is displayed in
the feed drive menu field in the information section of
settings (IV).
• Cutting length display
and the current cutting length in mm or
inches.
Depending on the number of blades that are used,
the cutting length can be set within a range from 3 -
62 mm.
4.4.1 Adjusting the cutting length
• Pressing the
5
key decreases the cutting length;
if the
5
key is held down for a longer time, the
cutting length will decrease faster.
• Pressing the
6
key increases the cutting length;
if the
6
key is held down for a longer time, the
cutting length will increase faster.
It is also possible to make a setting with the rotary
potentiometer:
• You can use the rotary potentiometer to select the
setting for the cutting length. The input field is
highlighted in colour.
• Pressing the rotary potentiometer allows you to
jump to the input field.
• You can use the rotary potentiometer to adjust the
desired cutting length.
• To exit the input field again, press the rotary
potentiometer.
The change is accepted immediately.
Two different cutting lengths (value 1/ value 2) can be
saved and retrieved with the multifunction lever (see
the chapter on the Multi-Function Lever).
1
2
3
4
5
6
7
8
A
B
C
D
BX500007_2
II
III
V
I
https://tractormanualz.com