II - 6
Safety
2.2.17 Telephones and radio sets
Telephones and radio equipment not connected to an
external antenna may cause malfunctions in the
electronic system of the vehicle and thus jeopardising
the operating safety of the vehicle.
2.2.18 Unauthorised conversion/
modification and manufacture of
spare parts
Modifications to the machine are permitted only with
the prior approval of the manufacturer. Original spare
parts and accessories authorised by the manufacturer
ensure safe use. The use of other parts may void the
liability for any consequential damage.
2.2.19 Non-permissible modes of
operation
The operational safety of the machine is only
guaranteed if it is used for its intended purpose in
accordance with the Chapter "General Information" of
these operating instructions. The limit values stated in
the data sheets must not be exceeded under any
circumstances.
6. Frequently check the hydraulic oil lines thoroughly
for proper condition and position with sufficient
clearance to contact edges that may be sharp.
7. Check the vicinity of the hot zones of the engine,
the exhaust system and pipes and the turbo
charger, and remove crop residues.
8. Take great care when handling fuels. Never fill in
fuel in the vicinity of unshielded flames or sparks
that may cause ignition. Do not smoke when filling
in fuel! Extreme fire hazard.
2.2.16 Maintenance
1. Always perform repair, maintenance and cleaning
work as well as troubleshooting only when the drive
is switched off and the engine stopped!
- Remove the ignition key!
2. The audio coastdown alarm, which is sounded after
the main drive is switched off, does not relieve the
operator of the obligation to make certain the
machine is at an absolute standstill before working
on it.
3. Regularly check that nuts and bolts are properly
seated and tighten them if necessary!
4. When performing maintenance work with the
implement raised, always secure it with suitable
supporting elements.
5. When replacing working tools with cutting edges,
use suitable tools and gloves!
6. Dispose of oils, greases and filters according to
the regulations!
7. Always disconnect the power supply before
working on the electrical system!
8. If protective devices and guards are subject to
wear, check them regularly and replace them in
good time!
9. When performing repair and electric welding work
on the forage harvester, always switch off the
engine, disconnect the power supply via the battery
power switch and disconnect the plug of the
electric system from the PLD controller on the
engine!
10. Replacement parts must, as a minimum, comply
with the technical requirements set by the
manufacturer of the implements!
This is ensured by using genuine KRONE
replacement parts!
11. Use only nitrogen for filling pneumatic
accumulators - Explosion hazard!
https://tractormanualz.com