IV - 8
Info Centre
4.2.4 Temporary Change of the Working
Width of the Direct Cutting System
• Pressing the
1
key decreases the working width;
if the
1
key is held down for a longer time, the
working width will decrease faster.
• Pressing the
2
key increases the working width
(up to the maximum for the fixed set width). If the
2
key is held down for a longer time, the working
width will increase faster.
It is also possible to make a setting with the rotary
potentiometer:
• You can use the rotary potentiometer to select the
setting for the working width. The input field is
highlighted in colour.
• Pressing the rotary potentiometer allows you to
jump to the input field.
• You can adjust the desired working width with the
rotary potentiometer (up to a maximum for the fixed
set width).
• To exit the input field again, press the rotary
potentiometer.
Activating the key on the multifunction
lever ((7) = raise lifting gear up to top)
causes the system to switch back to
the permanently set working width.
1
2
3
4
5
6
7
8
A
B
C
D
BX500010_1
II
III
V
I
7
BX500500
https://tractormanualz.com