Storage
24
BiG Pack 1290 HDP XC
Original Operating Instructions 150000752_01_en
337
NOTICE
Damage to the machine due to water damages with high-pressure cleaner
If the water jet from a high-pressure cleaner is aimed directly at bearings and electrical/
electronic components, these parts can be damaged.
Do not aim the water jet from high-pressure cleaner at bearings and electrics/electronic
components.
Lubricate the machine according to lubrication chart. Do not wipe off any grease that comes
out of bearing points as the hardened grease will provide additional protection against
moisture.
Grease the threads of setting screws and similar items.
Release the springs.
Release the parking brake and the flywheel brake.
Drain the condensation water from the compressed air reservoir.
Remove the drive chains and wash them out in petroleum. Do not use any other solvent.
Oil the chains after they are cleaned, mount and place them under tension.
Check chains and sprocket wheels for wear.
Disassemble the universal shaft. Grease the inner tubes.
Grease the grease nipples on the universal joint of the universal shaft and on the bearing
rings of the guard tubes, Lubricating universal shaft.
INFORMATION
Observe operating instructions of universal shaft manufacturer.
Lubricate the uncoated piston rods of all hydraulic cylinders liberally and insert as far as
possible.
Wet all lever joints and bearing positions, which cannot be lubricated, with oil.
Repair places with damaged paint and preserve all bare metal places thoroughly with rust
protection agent.
Check all moveable parts to make certain they move easily. If necessary, dismount, clean,
grease and remount.
If parts need to be replaced, use only KRONE original spare parts.
INFORMATION
Write down all repair jobs which must be performed by the next harvest and arrange for them
to be done with sufficient lead time. Your KRONE dealer is better able to perform
maintenance service and any required repairs outside of harvest season.