KROHNE OPTIFLEX 8200 C, Handbook

Page: 74 / 220

6
OPERATION
74
OPTIFLEX 8200 C/F/S
www.krohne.com 06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
6.3.2 How to get access to the Auto Setup procedure
Do the steps that follow:
• Push the [
^
^ ^
^
] button for more than two seconds.
i The screen shows a line. You must enter the password. Push the buttons under the display
screen 6 times (in total and in a given order) to get access to Configuration mode.
• Type in the password. The factory-set password is [> >>>], [
^
^ ^
^
], [ ], [ ], [>>>>] and [
^
^ ^
^
].
• Push the [>>>>] button (YES) to start the Auto Setup procedure.
• Push the [ ] button one time to scroll up to the Supervisor Supervisor Supervisor Supervisor menu.
CAUTION!
SIL-approved devices: SIL-approved devices: SIL-approved devices: SIL-approved devices: For data about critical device parameters, refer to the Safety Manual.
INFORMATION!
It is not possible to enter the 3.0.0 Service and 4.0.0 Master menus. These menus are for factory
calibration and approved personnel only.
INFORMATION!
HOW TO SET THE SUPERVISOR PASSWORD TO "ON" OR "OFF"
The supervisor password is set to "on" by default. If it is necessary to set this function to "off",
refer to Function description on page 79, Table 2: Supervisor menu, menu item Password Yes/No
(2.7.4).
INFORMATION!
HOW TO CHANGE THE SUPERVISOR PASSWORD
You can change the password for the supervisor menu. For more data, refer to Function
description on page 79, Table 2: Supervisor menu, menu item Password (2.7.5).