KROHNE OPTIFLEX 8200 C, Handbook

Page: 61 / 220

ELECTRICAL CONNECTIONS
4
61
OPTIFLEX 8200 C/F/S
www.krohne.com 06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
1 Remove the terminal compartment cover.
2 Remove the 4-pin connector.
3
Put the signal cable into the opening of the cable gland.
4
Put the electrical wires in the connector terminals. Tighten the terminal screws with a small
slotted-tip screwdriver. Make sure that the electrical wires agree with the terminals. For
more data, refer to the electrical schematic diagram in this section.
5
Put the connector into the 4-pin socket. Attach the Faston connector (drain wire).
6
Attach the terminal compartment cover.
7
Tighten the cable gland. Make sure that the probe electronics housing is correctly sealed.
How to connect the signal cable to the probe electronics housing
Figure 4-18: How to connect the signal cable to the probe electronics housing
CAUTION!
Bending radius of the signal cable:
≥
50 mm / 2
¨