KROHNE OPTIFLEX 8200 C, Handbook

Page: 214 / 220

10
APPENDIX
214
OPTIFLEX 8200 C/F/S
www.krohne.com 06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
I
L
M
Figure 10-4: Types of emulsion
1
Constant-mix emulsion
2
Gradually mixed emulsion
3 Interface distance
4 Oil
5 Water
6 Emulsion (constant mix, >5% of water)
7 Emulsion (gradually mixes with water)
Interface Interface Interface Interface A surface where two liquids meet.
Interface distance
Interface distance Interface distance
Interface distance This is a display option. It is the distance from the face of the flange to the
interface. See the diagram at the end of this section.
Interface level Interface level Interface level Interface level This is a display option. It is the height from the bottom of the tank (user-
defined) to the interface (or tank height - interface distance). Refer to the
diagrams at the end of this section.
Layer
Layer Layer
Layer This is a display option. It gives the thickness of top product. The layer must
be more than 50 mm or 2
¨
for accurate measurement of level and/or
interface. Refer to the diagrams at the end of this section.
Level
Level Level
Level This is a display option. It is the height from the bottom of the tank (user-
defined) to the surface of the top product (Tank height
–
distance). Refer to
the diagrams at the end of this section.
Mass Mass Mass Mass This is a display option. It shows the total mass of tank contents. Use a
mass table or a volume table to display measurement data with mass
units.
Measurement pulse Measurement pulse Measurement pulse Measurement pulse The device transmits a short, low-powered electrical pulse or wave
transmitted down a guide to the process. The process (or the probe end if
in TBF measurement mode) reflects the pulse back to the device.