KROHNE OPTIFLEX 8200 C, Handbook

Page: 117 / 220

OPERATION
6
117
OPTIFLEX 8200 C/F/S
www.krohne.com 06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
If an "Out of specification" status symbol is shown, refer to menu item 2.2.2 Diagnostic 2.2.2 Diagnostic 2.2.2 Diagnostic 2.2.2 Diagnostic
(Configuration mode / Supervisor menu) for more data.
For data on errors, error records and error codes, refer to
Error handling on page 117.
6.5.2 Error handling
How to find an error record
• Push [>>>>] and [ ] to enter configuration mode from normal mode.
• Push [>>>>], 9 × [ ] and [>>>>] to go to menu item 2.10.0 History 2.10.0 History 2.10.0 History 2.10.0 History.
• Push [>>>>] to look at errors recorded by the device. Push [ ] or [ ] for the selection of an error.
i The error record gives the number of times the error occurred and the time since the last
error message.
Description of data in menu item 2.2.2 Diagnostic
Figure 6-13: Error record data
1 Error code for the error
2 Number of times the error occurred
3 Time since the last error record (2 days, 18 hours, 16 minutes and 43 seconds shown in this example)
INFORMATION!
The time since the error occurred is measured in Days (D), Hours (H), Minutes (') and Seconds
("). It only includes the time when the device is energized. The error is saved in the memory of
the device when it is de-energized. The counter continues when the device is energized again.
Hardware
test
Description Normal
operating
range
Full range Cause Corrective action
Functioning
time
This shows the time in
seconds that the device is
energized.
— — —
For information
only.
Reset counter This shows the number of
times that the device goes
back to its initial settings.
— — —
For information
only.
Temperature,
converter
This shows the
temperature (in
°
C) of the
converter board.
-40...+80
°
C -50...+85
°
C See error 102
102 102
102 in
the table that
follows.
See error 102
102 102
102 in
the table that
follows.