7.4.2 Start-up
1.
Switch on compressed-air supply provided by the system owner.
2.
Establish the material supply for component A and component B provided by the system
owner.
3.
Point hand-held spray gun at a test surface.
Fig. 5: Pull lever
4.
Begin spraying process by pulling the pull lever ( Fig. 5/1).
5.
If necessary, adjust the spray pattern (
Ä
Chapter 7.5 ‘Adjusting the spray pattern’
on page 29
).
6.
End spraying process by releasing the pull lever ( Fig. 5/1).
Operating instructions
T-Dok-044-GB-Rev.0
[email protected], www.krautzberger.com
GB–28
Summary of Contents for HS-25/2K
Page 56: ......
