WARNING!
Danger due to misuse!
Misuse of the coating system can cause hazardous situations.
–
Only carry out the installation and start-up in accordance with the steps described in
these operating instructions.
–
Always observe the applicable country-specific safety, accident prevention, occupational
safety, and environmental protection regulations for the area of use for the hand-held
spray gun.
–
The chemical consistency of the materials used by us cannot always be reliably
assessed due to the large variety of utilised fluids, concentrations, temperatures, and
impurities. For this reason, please test the suitability because we cannot extend any
respective guarantees.
–
Adhere to the spray media manufacturer's safety data sheets.
–
Only use the manufacturer's OEM parts.
–
Only operate the hand-held spray gun while adhering to the values specified in (
Ä
Chapter 13.1 ‘Technical data’ on page 53
) or on the model plate.
–
It is mandatory to adhere to the maintenance and cleaning intervals.
–
The conformity of the product is voided in case of structural modifications.
–
Unauthorised persons, especially children and youth, must be prevented from entering
the hazard zone.
–
Never point the hand-held spray gun directly towards living beings, electrical systems or
devices.
–
Do not step into the area of the fluid jet. The angle of the fluid jet in front of the nozzle
may be up to 180° depending on the setting of the nozzle. The length of the fluid jet in
front of the nozzle can be 4 m depending on the setting.
–
When using coating material that present a risk for causing fires or explosions, avoid
open flames, red-hot parts, and equipment, tools, and parts that can create flammable
sparks in the work area. Adhere to the protective regulations for explosions.
–
Take preventative measures against unintended operation or triggering of the pull lever.
During breaks, hang up the hand-held spray gun at the suspension bracket so it is out of
reach for children.
–
–
Always securely store the hand-held spray gun away from children. Especially during
work breaks and in particular during the processing of hazardous materials, preventative
measures must be taken against the improper use through unauthorised persons! Clean
thoroughly prior to storage and/or transport.
–
A sufficient fresh air supply must be provided on the system owner's side. If necessary,
utilise suitable extraction systems.
–
Ensure sufficient earth connection, e.g. connection to the building earth connection!
Heating systems and water lines do not provide sufficient earth connection!
Operating instructions
T-Dok-044-GB-Rev.0
[email protected], www.krautzberger.com
GB–12
Summary of Contents for HS-25/2K
Page 56: ......
