CAUTION!
Risk of injury due to tripping over hoses and cables!
Hoses and cables are slipping and tripping hazards. A fall can cause injuries.
Note:
–
Always pay attention to hoses and cables in the work area.
–
Install cables outside of the work area in a designated cable conduit if possible.
–
Mark tripping hazards with black-yellow marking tape.
6.2 General installation information
Adhere to the following general information for the installation:
n
Only carry out the installation and start-up in accordance with the steps described in these
operating instructions.
n
Always observe the applicable country-specific safety, accident prevention, occupational
safety, and environmental protection regulations for the area of use for the spray booth.
n
Only use hoses and hose fittings that can withstand the pressures and other loads as neces-
sary.
n
In case of unforeseen fluid leakage, e.g. the loosening of a fluid hose connection or during the
bursting of a fluid hose, close the shut-off valve at the material source as quickly as possible!
It is recommended to install the shut-off valve within reach of the operator of the spray gun so
that - especially during the processing of hazardous materials - unforeseen fluid leakage can
be stopped quickly.
n
Mixing up the air or fluid connections can lead to permanent damage to the spray gun.
n
Reduce the supply air through the installation of a pressure regulator to a maximum of 6 bar.
n
Make sure that the connected compressed air is oil-free and free of solid matter.
n
Operate the spray gun with processed, dried compressed air (air quality pursuant to DIN ISO
8573-1: quality class 4).
n
Never point the compressed air at living beings.
During the work with flammable materials, the maximum coating material throughput must be
calculated.
6.3 Dimensions
All dimensions are approximate measurements in millimetres (mm)
Operating instructions
T-Dok-044-GB-Rev.0
[email protected], www.krautzberger.com
GB–20
Summary of Contents for HS-25/2K
Page 56: ......
