8.4 Maintenance schedule
The following sections describe the maintenance work that is required for the optimal and error-
free operation of the machine.
If increased wear becomes noticeable during regular checks, the necessary maintenance intervals
must be shortened based on the actual wear signs. In case of questions about maintenance work
and intervals, contact the Krautzberger customer service (see contact information on the last
page).
Interval
Maintenance work
Personnel
Prior to every start-up
Check the material and
compressed air hose lines
for damage and tight fit
before each use.
User
Check wear parts.
User
When necessary
Change nozzle set (
Ä
Chapter 8.6 ‘Change
nozzle set’ on page 39
).
Specialist
After each use
Clean hand-held spray
gun (
Ä
Chapter 8.5
‘Cleaning spray gun’
on page 36
).
User
8.5 Cleaning spray gun
WARNING!
Danger of injury due to improper cleaning!
–
Observe the safety data sheets of the medium manufacturer.
–
Observe the safety data sheets of the cleaning product manufacturer.
–
Do not use any halogenated cleaning products.
NOTICE!
–
Never use sharp edged tools (wire, spiral drill, or similar) to clean the spray gun and in
particular the air nozzles. Special flat/round brushes with plastic bristles are available to
use for cleaning.
–
Never immerse the entire device in solvent. This could destroy the seals and rinse off the
lubricant.
Operating instructions
T-Dok-044-GB-Rev.0
[email protected], www.krautzberger.com
GB–36
Summary of Contents for HS-25/2K
Page 56: ......
