Kramer Electronics Ltd.
VS-622DT
– Defining VS-622DT
6
Figure 2: VS-622DT 6x2 HDMI/HDBT Audio Matrix Switcher Rear Panel
#
Feature
Function
HDBT IN 1 RJ-45 Connectors
(1 to 2)
Connect to an HDBT transmitter (for example,
TP-580Txr
).
POE STATUS and LINK LEDs Light when PoE is available and an HDBaseT link is
established (HDBT IN 1, HDBT IN 2 and HDBT OUT 1).
Control RS-232 3-pin Terminal
Block
Connect to the serial controller to control the device.
AUDIO OUT Balanced Stereo
Audio 5-pin Terminal Block
Connectors (1 to 2)
Connect to an analog audio acceptor.
SETUP DIP-switches
Use to set the device behavior.
INPUT HDMI™ Connectors
(3 to 6)
Connect to HDMI sources.
ETHERNET RJ-45 Connector Connect to a remote network controller via a LAN.
HDBT OUT1 RJ-45 Connector Connect to an HDBT receiver (for example,
TP-580Rxr
).
HDMI OUT 2 Connector
Connect to an HDMI acceptor.
RESET Switch
Press and hold while powering on the device to reset to
factory default parameters.
Hi-Z OUT Terminal Block
Connectors
Lo-Z
– connect stereo output to Lo-Z speakers:
L+ and L- to the left speaker; R+ and R- to the right speaker.
Hi-Z (70V or 100V)
– connect Hi-Z and COM to mono Hi-Z
speakers.
PROG Mini USB Connector
Connect to a PC to perform a firmware upgrade.
RS-232 (G, Rx, Tx) Terminal
Block Connector
Connect to an RS-232 controlled device.
MAESTRO CONTROL 9-pin
Terminal Block Connectors
Connect to configurable buttons (configured via the
Automation page), such as the
RC-21TB
.
IR OUTPUT 2-pin Terminal
Block Connectors (1 to 4)
Connect to IR blasters/emitters.
GPI/O 2-pin Terminal Block
Connectors (1 to 2)
Connect to controllable sensors or devices (for example,
motion sensors). This port can be configured as a digital input,
digital output, or analog input.
RELAY 2-pin Terminal Block
Connectors (1 to 2)
Connect to a relay controllable device (for example, a
motorized projection screen).
Mains Power Connector,
Fuse, and Switch
Connect to the mains supply.