Kramer Electronics Ltd.
VS-622DT
– Connecting VS-622DT
8
Connecting VS-622DT
Always switch off the power to each device before connecting it to your
VS-622DT
. After
connecting your
VS-622DT
, connect its power and then switch on the power to each
device.
Note that not all the ports are connected in the following example.
To connect the VS-622DT Matrix as illustrated in the example in
1. Connect the HDMI and HDBT sources:
▪
An HDMI source (for example, a Blu-ray player) to the HDMI INPUT 6 connector
(3 to 6)
.
▪
A transmitter (for example, the Kramer
TP-580Txr
) to the HDBT IN 1 RJ-45 port
(1 to 2)
.
2. Connect the HDBT and HDMI outputs:
▪
The HDBT OUT 1 RJ-45 port
to a receiver (for example, the Kramer
TP-580Rxr
).
▪
The HDMI OUT 2 connector
, to an HDMI acceptor (for example, a display).
3. Connect the audio outputs:
▪
The AUDIO OUT 1 terminal block connector (1 to 2)
to a balanced audio acceptor
(for example, active speakers).
▪
The POWER AMP OUT terminal block connector
to either Lo-Z or Hi-Z
loudspeakers:
Lo-Z (4 to 8 ohm)
: connect the stereo output to Lo-Z speakers by connecting the left
loudspeaker to the “L+” and the “L-” terminal block connectors, and the right
loudspeaker to the “R+” and the “R-” terminal block connectors.
Hi-Z (70V or 100V)
: connect Hi-Z and COM to mono Hi-Z speakers.
Do not ground the loudspeakers.
4. Connect RS-232 3-pin terminal blocks:
▪
RS-232 Data
– connect directly to control the HDMI output acceptor (for example,
a display).
Alternatively, connect to a laptop to control peripheral devices that are connected to
transmitters/receivers that connect to the HDBT OUT ports.
▪
RS-232 Control
– Connect to a laptop to control
VS-622DT
.