
GG-09001 Edition 1.3
-
35
-
7-5 Replacing camera selector switch
①
Disconnect the connecter connected to the PCB.
②
Remove the switch while pushing the switch retaining latch using a flat-head screwdriver.
③
When installing a new switch, make sure that the switch is positioned in the correct direction.
Install the switch as shown in the figure below so that the soldered harness of the switch
comes closer to the side where “35mm” is shown.
7-6 Replacing base unit dipswitch PCB
①
When the switch panel section is already removed, remove the connector from the PCB. If
you prefer to replace the PCB without exposing the panel section, follow the step
⑤
of “5-3
Removing the switch panel section” to remove the PCB from the base, disconnect the cable
from the PCB, and replace the PCB with a new replacement PCB.
7-7 Replacing R/L selector switch
①
Remove the cable clamp. Undo 2 screws, remove the
switch assembly including the sheet
metal and replace the switch with a new replacement part
.
Summary of Contents for K9L48B
