
GG-09001 Edition 1.3
-
34
-
7-4 Replacing observation light intensity control and the flash
intensity switches
①
Loosen the retaining screw located in the hole of each knob, and remove the (2) knobs.
②
Disconnect the 2 cables connected to the PCB.
③
Undo 4 screws and remove the
switch assembly including the sheet metal
.
④
Using a
spanner, remove
the nut from each switch and replace the switch with a new
replacement part.
※
Work on one switch at a time because removing both switch at the same time may makes you
confused about which switch goes to which hole.
⑤
Using a
spanner, remove
the nut from each switch and replace the switch with a new
replacement part.
⑥
When installing the knob to the observation light intensity control switch, make sure that the
knob pointer travels from the minimum to the maximum settings shown on the panel.
⑦
When installing the knob to the flash intensity switch, make sure that the knob pointer points
toward the center of each setting from -3 to +3 shown on the panel.
Summary of Contents for K9L48B
