Korg microARRANGER, Owner'S Manual

Page: 226 / 244

224 Effects
Mono – Mono Chain
089: Rev-Gate

(Reverb – Gate)
This effect combines a mono ‐ type reverb and a gate.
f: Envelope Select, f: Src, g: Input Reverb Mix, g: Threshold
The “Envelope Select” parameter enables you to select
whether turning the gate on and off is triggered by the input
signal level or controlled directly by the modulation source.
You can select from Off to Gate2+Dmpr for the Src parameter
to specify the modulation source.
When “Envelope Select” is set to Input, the gate is controlled
by the level of signals that are the combination of the dry
sound and the reverb sound. When the signal level exceeds
the threshold, the gate opens and the reverb sound is output.
Normally, set “Input Reverb Mix” to Dry (the gate is controlled
only by the dry sound). If you wish to extend the gate time, set
the “Input Reverb Mix” value higher and adjust the “Thresh-
old” value.
a
[R] Reverb Time [sec]
Sets the reverberation time 0.1...10.0sec
High Damp [%]
Sets the damping amount in the high range 0...100%
b
[R] Pre Delay [msec] 0...200msec
Sets the delay time of the reverb sound and gate control signal
c
[R] EQ Trim
Table , “Sets the EQ input level,” on page 176 0...100
d
[R] Pre LEQ Gain [dB]
Table , “Sets the gain of Low EQ,” on page 176 –15...+15dB
Pre HEQ Gain [dB]
Table , “Sets the gain of High EQ,” on page 176 –15...+15dB
e
[R] Reverb Balance Dry, 1:99...99:1, Wet
Sets the reverb effect balance
f
[G] Envelope Select D-mod, Input
Switches between modulation source control and input signal control


Src Off...Gate2+Dmpr
Selects the modulation source that controls the gate when Envelope Select
is set to D-mod

Left
Right
Wet / Dry
Wet / Dry
Reverb
Balance
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
LEQ HEQ
EQ Trim
Reverb Pre Delay
Envelope - Control
D-mod
Input
Envelope Select
Gate
Input Reverb Mix
Reverb
Gate
Gate+Dmpr
g
[G] Input Reverb Mix Dry, 1:99...99:1, Wet
Sets the balance between the dry and reverb sounds of the gate control sig-
nal.

Threshold
Sets the gate threshold level 0...100

h
[G] Polarity +, –
Switches between non-invert and invert of the gate on/off state

Fx:005
i
[G] Attack
Sets the attack time 1...100

Fx:005
Release
Sets the release time 1...100

Fx:005
j
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175 –100...+100