Korg microARRANGER, Owner'S Manual

Page: 204 / 244

202 Effects
ER/Delay
Early reflection and delay effects
041: Early Refl

(Early Reflections)
This effect is only the early reflection part of a reverber ‐
ation sound, and adds presence to the sound. You can
select one of the four decay curves.
a: Type
This parameter selects the decay curve for the early reflec-
tion.
042: AutoReverse

(Auto Reverse)
This effect records the input signal and automatically
plays it in reverse (the effect is similar to a tape reverse
sound).
a: Rec Mode, b: Reverse Time
When ”Rec Mode“ is set to Single , you can set up to
1320msec for “Reverse Time. ”If recording starts during the
reverse playback, the playback will be interrupted.
When “Rec Mode” is set to
Multi , you can make another
recording during the reverse playback. However, the maxi-
mum Reverse Time is limited to 660msec.
If you wish to record a phrase or rhythm pattern, set “Rec
Mode” to
Single . If you record only one note, set “Rec Mode”
to Multi .
The “Reverse Time” parameter specifies the maximum dura-
tion of the reverse playback. The part in excess of this limit
will not be played in reverse. If you wish to add short pieces of
the reverse playback of single notes, make the “Reverse
Time” shorter.
ER/DELAY
a
Type Sharp, Loose, Modulated, Reverse
Selects the decay curve for the early reflection

b
ER Time [msec]
Sets the time length of early reflection 10...800msec
c
Pre Delay [msec] 0...200msec
Sets the time taken from the original sound to the first early reflection
d
EQ Trim 0...100
Sets the input level of EQ applied to the effect sound
e
Pre LEQ Gain [dB]
Table , “Sets the gain of Low EQ,” on page 176 –15.0...+15.0dB
Pre HEQ Gain [dB]
Table , “Sets the gain of High EQ,” on page 176 –15.0...+15.0dB
f
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175 –100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
EQ Trim
+
EQ Trim
Pre Delay
Early Reflections
LEQ HEQ
Sharp
Loose
Modulated
Early Reflections - Type
Reverse
Dry
Pre Delay ER Time
a
Rec Mode
Sets the recording mode Single, Multi

b
Reverse Time [msec] 20...1320msec
Sets the maximum duration of the reverse playback

c
Envelope Select D-mod, Input
Selects whether the start and end of recording is controlled via the modula-
tion source or the input signal level

,
Src Off...Tempo
Selects the modulation source that controls recording when Envelope Select
is set to D-mod

d
Threshold 0...100
Sets the recording start level when Envelope Select is set to Input

e
Response 0...100
Sets the speed of the response to the end of recording

Fx:031
f
Direct Mix Always On, Always Off, Cross Fade
Selects how a dry sound is mixed

Fx:031
g
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175 –100...+100
Input
D-mod
Envelope Select
D
-mod
Envelope Control
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Auto Reverse
Direct
Mix
Rec/Reverse Play
Control
Rec Rec
Rec Mode/Reverse Time
Input
Rec Mode = Single
Rec Mode = Multi
Time
Reverse Time Reverse Time
Envelope Select = Input
Reverse Reverse