Konica Minolta AccurioLabel 230, Quick Manual, Page: 174 / 194

6-24 AccurioLabel 230
A media feeding error occurs 6 6.5
6.5.3 The jam code J-3105 is displayed
The jam code J-3105 is displayed when the machine detects that the delivering roller stops while printing
or conveying paper.
Follow the procedures below to solve the problem:
STEP 1: Check the Position of the Media

Check if the media is set in the right position.
% For details, refer to page 5-10.
STEP 2: Clean the Adhesive Sticking on the Parts

Clean the leading section or the delivering section if it is dirty with adhesive.
%
For details, refer to page 5-5, page 5-7.
STEP 3: Clear Paper Jams

Remove the paper inside the main body, and then open and close the front door of the main body
to clear the paper jam.
%
For instructions on how to remove the paper, refer to page 6-13.
%
IMPORTANT: If the paper cannot be pulled out from the delivering section, contact your service rep-
resentative. Paper may coil around the
fixing unit . Pulling out the paper with excessive force may
cause machine troubles.
6.5.4 White spots appear on the output paper
White spots (discharge noise) size of 0.1 mm to 1 mm / 0.004" to 0.04" may appear on the print output. This
may occur especially on film type media.
Follow the procedures below to solve the problem:
STEP 1: Check the Position of the Media

Check if the media is set in the right position.
% For details, refer to page 5-10.
STEP 2: Clean the Adhesive Sticking on the Parts

Clean the leading section if the roller is dirty with adhesive.
%
For details, refer to page 5-5.
STEP 3: Adjust the Second Transfer Output

Adjust MACHINE - [Paper Setting] - [Change Setting] - [Process Adjustment] - [2nd Transfer Out-
put Adjustment].
%
[Process Adjustment] is not displayed by default. For details, contact your service representative.